Viden om installation af PPR-rør
Rørledningsforbindelsesmetoder inkluderer svejsning, hot melt og gevindforbindelse. PPR-rør smelteforbindelse er den mest pålidelige, nemme at betjene, god lufttæthed, høj grænsefladestyrke. Rørforbindelsen vedtager den håndholdte svejseanordning til smelteforbindelse. Støv og fremmedlegemer skal fjernes fra rør og tilbehør inden tilslutning. Når maskinens røde lys er tændt og stabilt, skal du justere rørledningen (delen), der skal tilsluttes DN< 50="" hot-melt="" depth="" of="" 1-2mm,="" dn="">< 110="" hot-melt="" depth="" of="" 2-4mm. when="" connecting,="" insert="" the="" tube="" end="" into="" the="" heating="" sleeve="" without="" rotation="" to="" reach="" the="" predetermined="" depth. at="" the="" same="" time,="" push="" the="" pipe="" fittings="" to="" the="" heating="" head="" without="" rotation="" for="" heating.="" after="" reaching="" the="" heating="" time,="" immediately="" remove="" the="" pipe="" and="" fittings="" from="" the="" heating="" sleeve="" and="" the="" heating="" head="" at="" the="" same="" time,="" and="" insert="" the="" pipe="" and="" fittings="" into="" the="" required="" depth="" rapidly="" without="" rotation="" and="" with="" uniform="" force="" to="" make="" the="" joint="" form="" a="" uniform="" flange. within="" the="" specified="" heating="" time,="" the="" welded="" joint="" can="" be="" corrected,="" but="" rotation="" is="" strictly="" prohibited. when="" heating="" pipes="" and="" fittings,="" prevent="" excessive="" heating="" to="" thin="" the="" thickness. the="" pipe="" is="" deformed="" in="" the="" pipe="" fittings. do="" not="" rotate="" during="" hot="" melt="" intubation="" and="" calibration. there="" shall="" be="" no="" open="" fire="" on="" the="" operation="" site,="" and="" it="" is="" strictly="" prohibited="" to="" dry="" and="" bend="" the="" pipe="" with="" open="" fire. the="" heated="" pipe="" and="" fittings="" should="" be="" aligned="" vertically="" with="" light="" force="" to="" prevent="" bending="" of="" the="" elbow. after="" connection,="" the="" pipe="" and="" pipe="" fittings="" must="" be="" held="" tightly="" for="" enough="" cooling="" time,="" and="" can="" be="" released="" after="" cooling="" to="" a="" certain="" extent. when="" pp-r="" pipe="" is="" connected="" with="" metal="" pipe="" fitting,="" pp-r="" pipe="" with="" metal="" insert="" should="" be="" used="" as="" transition,="" the="" pipe="" fitting="" is="" connected="" with="" pp-r="" pipe="" by="" hot="" melt="" socket,="" and="" when="" connected="" with="" metal="" pipe="" fitting="" or="" hardware="" fittings="" of="" sanitary="" ware,="" thread="" connection="" is="" used,="" and="" polypropylene="" raw="" material="" belt="" should="" be="" used="" as="" sealing="">Hvis moppepuljen er forbundet til et tryk, skal du installere en indvendig albue (gevind) i enden af PPR-røret på den.I forbindelse med rørledningsinstallation må du ikke udøve for meget kraft for ikke at beskadige skruespændebeslagene og forårsage lækage ved forbindelsen. Rørskæring kan også skæres med en speciel rørsaks: Rørsaksens bajonet skal justeres for at være i overensstemmelse med diameteren på røret, der skal skæres, og kraften skal påføres ensartet, når røret afskæres. Efter skæringen skal bruddet afrundes af den understøttende rundere. Når røret er brudt, skal sektionen være vinkelret på rørets akse uden grater.